24
Chapter 1
Card basics (Cont.)
1
Make sure the camera is turned off (i.e. the
mode dial is set to OFF).
2
Open the card cover.
3
Inserting the card
Insert the card fully with the contact area
facing towards the monitor side. Insert
until you feel it locked into place.
● Hold the card in a straight orientation to the
card slot. Do not attempt to insert the card at
an angle.
● Note the orientation of the card. If it is
inserted incorrectly, it may become jammed.
Removing the card
Push in the card lightly to unlock it, then
pull it out.
4
Close the card cover securely until it
clicks.
Inserting/removing the card
● Never open the card cover, eject the card, remove the batteries, or
disconnect the optional AC adapter while the camera is in use or the
camera is communicating with a computer. Doing so could destr
oy all
data on the card.
● Destroyed data cannot be restored.
To Next Page
Loading...
