188
Chapter 12
Troubleshooting (Cont.)
POSSIBLE CAUSES
CORRECTIVE ACTION
REF. PAGE
Picture rotate, Picture protect, Single-frame erase, All-frame erase,
Print reserve and Card formatting cannot be performed.
1 A write-protect
adhesive seal is affixed
to the card.
1 Use the card after peeling
off the seal. Do not reuse
the write protect seal.
P. 28
When the camera is connected to a computer, an error message
appears while data is being transferred to the computer.
1 The cable is not
plugged in correctly.
2 The batteries are
exhausted.
3 The USB driver is not
installed properly.
1 Connect the cable correctly.
2 Replace the batteries with
new ones or use the
optional AC adapter.
3 For Windows 98/98 SE
users: Install the USB driver
again following the provided
“SOFTWARE
INSTALLATION GUIDE”.
P. 173
P. 25, 183
1 The flash is in the auto-
flash mode.
1
This “red-eye phenomenon”
occurs with all cameras when a
flash is used. It is caused by
light from the flash reflecting off
the retina at the back of the
eye. Red-eye varies depending
on the individual and the
shooting conditions such as
ambient lighting. Use of the
Red-Eye Reducing Pre-Flash
mode significantly reduces this
phenomenon.
P. 84
The subject’s eyes appear red in pictures recorded with the flash.
To Next Page
Loading...
