31
Power on/off (Cont.)
Chapter 1
When the power is turned on/off, a startup/shutdown image is displayed on
the monitor and startup/shutdown sound is output.
You can select your favorite image for this function (P. 151) and adjust the
sound volume (P. 131).
Monitor appearance and sound
Startup/Shutdown image (factory default setting)
● Leaving the camera switched on for an extended period of time may cause
the images to heat up and increase the chances of noise in the
photographs.
● When there is insufficient space remaining on the card, the camera beeps
and CARD FULL appears on the monitor. If this happens, replace the card
with a new/storable card or erase unwanted pictures in the existing card to
make space.
● The number of storable pictures may not be reduced every time a picture is
taken, or increased when a picture is erased. The amount of data varies
depending on the subject.
● Do not put anything that is sensitive to magnetism (credit cards, floppy
disks, etc.) near the camera. Doing so de-magnetize the item and destroy
any data it contains.
● If the camera stops working
T To save battery power, the camera automatically enters the Sleep
mode after about 3 minutes of non-operation. The camera activates
again as soon as you touch the zoom lever or mode dial, etc. Sleep
time interval can be set in the P, A/S/M and modes (P. 153).
TIPS
To Next Page
Loading...
