161
6
Appendix
If a problem arises
Possible cause Corrective action
Ref.
page
The camera does not respond or the monitor does not turn on
n
The power is off.
n
Turn the camera on. *1
o
The battery is exhausted.
o
Charge the battery. *1
p
The battery is temporarily
unable to function because of
the cold.
p
Warm the battery by putting it
in your pocket for a while.
–
q
There is condensation inside
the camera.
q
Turn the camera off and wait until
it dries before turning it on again.
–
r
The camera turned off auto-
matically in the shooting mode.
r
To save battery power, the cam-
era automatically enters the
sleep mode after about 3 min-
utes of no activity. Press any
button such as the zoom button.
*1
s
The camera turned off auto-
matically in the playback
mode.
s
To save battery power, the
camera automatically enters
the sleep mode. Turn the cam-
era on again.
*1
t
The camera is connected to a
computer.
t
The camera will not operate while
it is connected to a computer.
–
The camera does not work properly
n
You used a card that had been
formatted on a computer.
n
This may damage the card or
the pictures files on the card. It
may also make the recording
time exceptionally long or pre-
vent playback. Format the card
with the camera.
P. 9 7
No picture is taken when the shutter button is pressed
n
The card is full.
n
Erase unwanted pictures or
insert a new card. Before eras-
ing, transfer all important pic-
tures to a computer.
*1
P. 72,
73,
P. 142
o
The flash is charging.
o
Wait until the flash charging
lamp stops blinking.
P. 165
p
The picture is being written to
the card.
p
Wait until the card access mark
stops blinking.
P. 165
q The memory gauge is full. q Wait until there is room in the
memory gauge.
*1
*1 See the separate Basic manual provided.
To Next Page
Loading...
