Troubleshooting
165
10
Appendix
(When the camera is connected to a computer or printer
Possible cause Corrective action
Ref.
page
The printer fails to connect.
PC was selected on the
monitor after connecting
the camera to the printer
with the USB cable.
Remove the USB cable, and start again from
Step 1 of “Connecting the camera to a
printer”.
P.125
The printer does not
support PictBridge.
Refer to the printer’s instruction manual or
contact the manufacturer.
–
The camera is not recognized by the computer.
The USB driver has not
been installed.
Install OLYMPUS Master. P.144
d4250_e_00_0_bookfile.book Page 165 Friday, December 24, 2004 11:45 AM
To Next Page
Loading...
