Function shooting (black & white/sepia)
78
5
More useful functions
1 Press the shutter button fully to take
the picture.
• Pressing the shutter button halfway locks
the focus and exposure.
• The self-timer lamp lights for approximately
10 seconds, then starts blinking. After
blinking for approximately 2 seconds, the
picture is taken.
• To cancel the self-timer, press the N
button.
• The self-timer mode is automatically
canceled after one shot.
This feature lets you add a special black & white or sepia effect to your
pictures.
Top menu [MODE MENU] [CAMERA] [FUNCTION] [BLACK &
WHITE] / [SEPIA] / [OFF] g“Menus” (P.16)
Note
• If sequential shooting is attempted in self-timer mode, the camera shoots 5
frames at most regardless of the setting.
Note
• White balance, white balance compensation and saturation cannot be used
during function shooting.
Self-timer lamp
Function shooting (black & white/sepia)
Mode dial
d4250_e_00_0_bookfile.book Page 78 Friday, December 24, 2004 11:45 AM
To Next Page
Loading...
