You can run through all the stored pictures
automatically.
This function works when the lens barrier is closed.
1 Display the picture by turning on the LCD monitor ON/OFF
button.
2 Press the Function button to select the Slide-Show mode,
then press the OK button to start the Slide-Show.
3 Press the Function button again to stop at the currently
displayed picture.
● The Slide-Show does not stop until you cancel the
operation. Press the Function button to stop it. (When the
AC adapter is not connected, the power turns off
automatically after about 30 minutes regardless of the
power source.)
● The Slide-Show is also available in the Index-Display
mode. (p. 124)
LCD Monitor
Écran ACL
Monitor LCD
OK button
Touche OK
Botón OK
Function button
Touche de fonction
Botón de función
To Next Page
Loading...
