No. Parts name Screw
Grease Adhesive
Remark
PLATE
(A)
(B)
(C)
(D)
(E)
ABS3X8SA, 2pcs. (*1)
FINE ADJ. KNOB
PLATE
(G)
Attach it with double coated
adhesive tape.
WASHER
COARSE FOCUS
CWK2.6X6SA, 3pcs. (*4)
(J)
(L)
FOCUSING GUIDE
(M)
(N)
(O)
(P)
KNOB
BOTTOM PLATE
PINION SECTION OT1026
WASHER
(I)
(F)
SPRING WASHER
(K)
COVER
FINE SHAFT
(H)
FINE ADJ. KNOB
ASS’Y
COARSE ADJ. KNOB
MOUNT
ADJ. KNOB ASS’Y
COVER
UNIT
CWK3X6SA, 3pcs. (*2)
ACU3X4SA, 2pcs. (*3)
CSK2.6X6SA, 2pcs. (*5)
CUK2.6X5SA, 1pc. (*6)
CUKK3X6SA, 1pc. (*7)
AB4X14SA, 3pcs. (*8)
ACU3X10SA, 1pc. (*9)
CUKS3X8SA, 4pcs. (*11)
ACU3X6SA, 2pcs. (*12)
OT2008
OT2008
OT2008
OT2006
OT2012 OT3111
OT2008
OT1378
OT2012
Apply grease to the circumference
of the shaft(a).
Apply grease to the outer surface.
Apply grease to the outer surface.
While holding the coarse adj.
knob ass’y , screw the fine shaft
mount into it.
Check that the gears moves
smoothly.
Apply grease to the outer surface.
Rotating tension:
Standard: 0.3N -1.2N(OT3225)
Rotating tension:
Standard: 6N -25N(OT3223)
Apply grease to the shaft hole.
Fit the protrusions into the holes
of frame.
Push it in the arrow directions
when assembling it.
(Refer to C-9.)
The screw on the right back is
with HWB3SA.
For screw positions, refer to C-13.
When removing the Pinion
section, it is necessary to remove
the foucusing guide unit(M)
and bottom plate(O).
Fixing screw: ACU3X6SA(*12)
Also remove the four screws(*10)
of cover.
(Refer to the figure on C-9.)
CKX31/CKX41 C. DISASSEMBLY AND ASSEMBLY PROCEDURES
C-10
OT2008
CTK3X6SA, 4pcs. (*10)
To Next Page
Loading...
