7
}By attaching the optional CH3-CH cord hanger on the rear of the
microscope frame, the power cord can be accommodated by winding
around the hanger.
Insert the hook ² of the cord hanger @ into the air vent groove on the
rear of the microscope by aligning the attaching position ³, and
clamp by sliding the cord hanger downward while pushing it against
the microscope with a strong force.
#Do not hold the microscope frame by the cord hanger when
carrying the microscope. Otherwise, the cord hanger may be
detached during transport, resulting in falling of the microscope
and personal injury.
Removal
To prevent electric shock, disconnect the power cord first. Also
make sure you use the provided Allen wrench, not a thin Allen
wrench.
Move the microscope frame to the edge of the table |, apply an
Allen wrench ƒ onto the lower part of the cord hanger @, and
move the entire hanger upward by pushing the Allen wrench
toward the directions 1 and 2 to remove. (Fig. 8)
Fig. 7
Fig. 8
Attaching the Optional Cord Hanger (CH3-CH) (Figs. 7 & 8)
3
To Next Page
Loading...
