49
3
Connecting to Your PC
2 While pushing down the top of the recorder, set
the recorder on the cradle. In this case, make sure
that concavity on the rear of the recorder fits
convexity of the cradle.
“REMOTE” is displayed on recorder if the USB cable
is connected.
Remove the recorder from the cradle
Follow step 1 in “Disconnecting from Your PC” (☞ P.47).
1
Make sure that the recorder's record/play
indicator lamp isn't flashing, and remove the
recorder from the cradle.
Hold the cradle with your hand, and raise the recorder
from the top end to remove it from the hook, as shown
in the illustration.
.................................................................................................................................................................
Notes
• Do not touch the connection point on the front of the cradle (at the low end), as that may cause bad
connection.
• The cradle does not have the recharging function.
To Next Page
Loading...
