Olympus DS-7000 - Setting Time and Date; Changing Time and Date Settings

19
1
EN
Setting time and date
Setting time and date
Changing the time and date
If the current time and date is not correct, set it using
the procedure below.
1 While the recorder is in stop mode, press
the OK/MENU button.
2 Press the 9 or 0 button to select
[ Device Menu ] tab.
• You can change the menu display by moving
the settings tab cursor.
3 Press the + or − button to select
[ Time & Date ].
4 Press the OK/MENU button.
• The following steps are the same as Step 1
through Step 3 of “ Setting time and date
[Time & Date] ” ( ☞ P.18).
5 Press the F3 ( EXIT ) button to close the
menu screen.