DSX1000
If no power supply cord is provided, please select the proper power supply cord for the equipment by referring to
“Specifications” and “Certified Cord” below:
Caution : In case you use a non-approved power supply cord for Olympus products, Olympus can no longer
warrant the electrical safety of the equipment.
Specifications
Voltage rating
Current rating
Temperature rating
Length
Fittings configuration
125 V AC (for 100-120 V AC area) or, 250 V AC (for 220-240 V AC area)
6 A minimum“60 ˚C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC
configuration appliance coupling.
Table 1 Certified cord
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked
with an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of the
agencies listed in Table 1. In case you are unable to buy locally the power supply cord which is approved by one of
the agencies mentioned in Table 1, please use replacements approved by any other equivalent and authorized
agencies in your country.
Country Agency Certification mark Country Agency Certification mark
Argentina IRAM Italy IMQ
Australia SAA Japan JET
Austria ÖVE Netherlands KEMA
Belgium CEBEC Norway NEMKO
Canada CSA Spain AEE
Denmark DEMKO Sweden SEMKO
Finland FEI Switzerland SEV
France UTE United
Kingdom
ASTA
BSI
Germany VDE U.S.A. UL
Ireland NSAI
9. Proper selection of the power supply cord
51
9. Proper selection of the power supply cord
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
