95
EN
9
Customizing your camera
AELMetering
You can set the metering mode when pressing the AEL/AFL button to lock the exposure.
• [AUTO] performs metering in the mode selected under [METERING].
BULB TIMER
You can select the maximum time (in minutes) for bulb shooting.
Custom Menu 1f # CUSTOM
#X-SYNC.
You can set the shutter speed that will be used when the flash fires. The speed can be set
from 1/60 to 1/180 in 1/3 EV increments.
• For details on the synchronization speed of commercially available flashes, refer to their
manuals.
#SLOW LIMIT
You can set the slow limit of the shutter speed that will be used when the flash fires. The
speed can be set from 1/30 to 1/180 in 1/3 EV increments.
w+F
When set to [ON], it will be added to the exposure compensation value and flash intensity
control will be performed.
AUTO POP UP
In AUTO or scene mode, the built-in flash pops up automatically in low light or backlight
conditions. When set to [OFF], the built-in flash will not pop up automatically.
Custom Menu 1g K/COLOR/WB
ALL >
You can apply the same compensation value to all the white balance modes at once.
[ALL SET] The same compensation value applies to all WB modes.
[ALL RESET] The WB compensation value settings applied to each WB mode are all
cleared at once.
If you select [ALL SET]
1) Use bd to select the color direction.
Toward A: Amber-Blue/Toward G: Green-Magenta
2) Use ac to set the compensation value. g“WB compensation” (P. 65)
Releasing the AEL/AFL button takes a sample image. You can check the white balance
you have adjusted.
If you select [ALL RESET]
1) Use ac to select [YES].
s0018_e_00_0_unified.book Page 95 Tuesday, March 18, 2008 4:08 PM
To Next Page
Loading...
