EasyManua.ls Logo

Olympus E-M1 MARK II - Using a flash ( Flash photography)

Olympus E-M1 MARK II
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
57
EN
Shooting
2
*4 The record mode can be set.
g [n Speci cation Settings] (P. 100)
Depending on the type of card used, recording may end before the maximum length is
reached.
Bit rate selection may be unavailable at some settings.
Using a ash ( Flash photography)
1
Remove the hot shoe cover and attach the ash to the camera.
• Slide the ash unit all the way in until it contacts the back of the shoe and is securely
in place.
Hot shoe cover
Changing orientation of the ash
You can change the vertical and horizontal orientation of
the ash unit. Bounce shooting is also possible.
Note that when used for bounce photography the ash
may not fully illuminate the subject.
Removing the ash unit
Remove the ash unit while pressing the UNLOCK switch.
2
1
UNLOCK switch

Table of Contents

Other manuals for Olympus E-M1 MARK II

Related product manuals