Olympus ENDO-AID - Switching between Visualization Modes; Using the CAD and Mode 1 Button

Switching between Visualization Modes
Using the CAD and Mode 1 Button
CAD Button
Mode 1
Button
Time
Elapsed*
* Unless in unlimited
Target Mode duration.
Mode 1
Button
CAD Button
CADe: Off CADe: Normal Mode CADe: Target Mode
Mode 1 Button (Press and Hold)
In the “remote switch” section of your CV-1500 user presets you can set the scope switch of your
preference to control your ENDO-AID CADe. Look for the following options:

Option dev. control 1: Emulates the CAD button, i.e., to turn CADe on and off.
Option dev. control 2: Emulates the MODE 1 button, i.e., to toggle between visualization modes.
It is suggested to use “Option dev. control 2” on switch 2. This way, the user can easily start
ENDO-AID CADe and toggle through the visualization modes.