Olympus ESG-410 - Mode Characteristics According to IEC 60601-2-2

105
Additional information
Mode name Tone sequence Description
Blend
BlendCut
FineCut
PowerCut
Pure
PureCut
Constant tone pitch at
554 Hz
Continuous tone during cutting.
PulseCut Fast
PulseCut Slow
Alternating tone pitches
at 554/440 Hz
Continuous tone during cutting.
ForcedCoag
Fulgurate
PowerCoag
SoftCoag
Spray
SprayCoag
Constant tone pitch at
440 Hz
Continuous tone during coagulation.
17.2.4 Other tones
Startup tone (Olympus jingle)
Duration......................................................................................................................... 0.375 s
Frequency ................................................................................................... 500/1000/2000 Hz
Volume ............................................................................................ ≥ 65 dB(A), not adjustable
Touch tone
Duration........................................................................................................................... 0.09 s
Frequency ..................................................................................................................... 500 Hz
Volume ............................................................................................ ≥ 65 dB(A), not adjustable
17.3 Mode characteristics according to IEC 60601‑2‑2
Details on the mode characteristics are described in the section “7.4 Description of modes”
on page 55.