2022/01/10 05:45 5/11 Olympus IX71 Microscope Z-Axis Motor Drive Installation
Applied Scientific Instrumentation - https://asiimaging.com/docs/
Remove motor drive assembly from base plate (if attached) by using the 7/64 inch Allen wrench to
remove the horizontal adjustment screw.
Use the 7/64 inch Allen wrench to loosen the two vertical adjustment screws.
Slide the baseplate assembly completely under the microscope as shown until the small stop
plate located on the baseplate is completely against the side of the microscope. This stop plate
should be parallel with the bottom of the microscope. Align the plate beneath the focus knobs.
To Next Page
Loading...
