28
3.5 Insertion of batteries into the foot switch
MAJ-2301 INSTRUCTION MANUAL
Ch.3
• To facilitate removal of exhausted batteries from the battery compartment, pull up
the ribbon.
• In general, the battery performance drops as the temperature decreases. This is
important to note when using the instrument in a low-temperature environment.
Even when the performance of batteries drops due to a low temperature, it may
sometimes be restored when the instrument is brought back under a normal
temperature.
• The ON and flashing conditions of the communication status indicator vary
depending on the status of communication with the wireless unit.
ON: Communication with the wireless unit is established.
Flashing or OFF: Communication with the wireless unit is not established.
• Each indicator the ON / flashing (slow) automatically turns off in about 2 minutes
and flashing (early) automatically turns off in about 3 seconds. To check again,
press one of the switches of foot switch again.
8 If the remaining battery power is almost or completely exhausted, repeat Step 1 to 7
above again.
To Next Page