36
4.2 Inspection workflow
MAJ-2301 INSTRUCTION MANUAL
Ch.4
Refer to the inspection workflow below. Follow each step of the workflow for inspection of this
instrument before use.
The remaining battery power can be inspected only when the foot switch is in the
wireless status. Disconnect the foot switch cable before proceeding to the
inspection.
4.2 Inspection workflow
1
Check the power status of the foot switch (for wireless
control).
Section 4.3 on page 36
2
Check the foot switch cable (for wired control).
Section 4.4 on page 39
3
Check that the foot switch is operable.
Section 4.5 on page 41
4.3 Inspection of remaining battery power (for
wireless control)
To Next Page