Olympus OM-2 - Page 64

MOTOR DRIVE GROUP UNITS
• M.AC Control Box
AC transformer for use with household
current . Incorporates a selector switch
between single - frame operation and
sequential exposure operation , a termi -
nal for the relay cord and a timer for
exposures in intervals from 4 frames per
second to one frame every 120 se c.
• M.15V Ni ·Cd Charger 1
This unit is ne cessary to c harge the
M . 15V Ni · Cd Control Pack 1. By
c harg i ng for about 4 to 5 hours , the
Control Pack is c apable of power i ng
sequential filming of 40 rolls of 36 ex ·
posu res films .
.250 Film Back 1,250 Film Magazines
Can be quickly attached to the OM
Body in place of the standard camera
back, and used with the Motor Drive 1
or Winder 1 for roil films up to 250 ex-
posures (10m or 32.8ft long) . Two
Magazines are necessary, one magazine
holds the bulk film and a second maga-
zine is used as a film take-up.
-
I
• Relay Cords 1. 2m and 10m
Extension cords for remote control ; one
is 1 . 2m (3.9ft), the other is 10m
(32.8ft).
63
• 250 Film Loader
This unit is used in the darkroom for
loading the 250 Film Magazine from
33m (100ft .) bulk film rolls . A built - in
mechanism automatically stops loading
at preset film lengths .
• Compartment Case L
•
Partitioned Insert
Can be slung over the shoulder or car -
ried by hand . If used with an optionally
available partitioned insert, the Case L
accommodates motor drive equipment .
• M.REMOTE CORDS 1.2m / 5m
The M . Remote Cord remote - contro ls
the Olympus Motor Drive 1 and Winder
1 units equipped with a re mote control
jack by a flick of a sw i tch .