Olympus OM-2 - Operation

WI NDER 1 OPERATION
Shutter Release
Remote Control Jack
Guide Pin
Winder 1
37
Attaching the Winder 1
CD Remove the motor drive socket cap.
® Pull up and rotate the switch dial to the "OFF" position.
® Remove the M.6V Battery Holder 1 from 'inside the
winder, insert four 1. 5V penlight (AA) size batteries
into the battery holder, and put it back into the compart-
ment. Insert the guide pin into the guide pin hole on the
camera base plate . Turn the clamping screw clockwise
until the Winder 1 is securely attached to the camera
base
plate.
Taking the pictures
CD Pull up and rotate the switch dial to the "SINGLE"
position.
® Press the shutter release.
NOTE: The removed motor drive cap can be stored in the
socket cap storage positioned on the underside of the battery
holder compartment.