Olympus OM-2 - Page 37

~---- ---- ~-- ------~ .
• Attaching the M. l8V Control Grip 1
CD Remove the M . 18V Batte ry Holder 1, insert twelve
1.5V penlight (AA) size batteries into the battery holder,
and re-insert the battery holder into the Control Grip.
<V Align the red index line on the rear of the control grip
with the red index line on the rear frame of the motor
drive unit until the mounting catch is engaged . Carefully
push the control grip forward until it snaps into the
front of the motor drive.
NOTE : A flat - type rechargeable power source, the M . 15V
Ni-Cd Control Pack 1, is also available . - For the detail of
motor drive units, refer to page 59 .
36
• Photography with the Motor Drive Units
Using the M . l8V Control Grip 1
CD Unlock the shutter release lock lever on the Control Grip
by moving it forward and upward .
<V Turn the mode selector on the Control Grip to either
" SINGLE" or "SEQUENCE". Set the mode selector to
the " OFF " position when the Motor Drive 1 is not in
use.
NOTE: In either mode, automatic exposure control is
possible in the full range of shutter speeds, and manual
exposure is possible from 1 second to 1/ 1000 second .
@ Release the shutter .
NOTE : You may use either the shutter release on the
Control Grip 1 or the shutter release on the Motor Drive 1
to trigger the shutter .