Olympus OM-2 - Page 36

MOTOR DRIVE PHOTOGRAPHY
Motor Drive 1
M.18 Control Grip 1
Remote Control Jack
Camera Coupling
Terminal
'--""ITlUlile Screw
35
• Attaching the Motor Drive 1
CD R emove the motor drive socket cap from the camera
base
plate by rotating it count er-cloc;kwise with a coin
until the index dot on the cap is aligned with the index
dot on the camera.
To replace the cap, align the index dot on the cap with
the index dot on the camera, and turn the cap clockwise
with a coin until the index dot on the camera is aligned
with the groove on the cap.
® In sertthe motor drive guide pin into the guide pin hole
on the camera base plate . To assure proper connection,
adjust the position of the Motor Drive 1 until it is flush
with the camera. Turn the clamping screw clockwise
until the Motor Driv e 1 is securely attached to the
camera base plate.