To play back camera images on a TV
,_, Connect the TV and camera.
C..... t to the TV video C..... t....... _"._"__/ _:__'_"_
input jack (yellow) and __ i59"f""
M
.-
_r Multi-connector
AV cable (supplied)
2 Use the camera to select the same video signal system as the one of connected TV ([NTSC]/
[PAL]).
3. Turn on the TV, and change "INPUT" to "VIDEO (an input jack connected to the camera)".
Fordetaits on changing the input source of the TV, refer to the TV's instruction manual.
Set the mode dial to [E], and use _(,'.',/i_} to select the image for playback.
_ Depending on the TV's settings, the displayed images and information may be cropped.
Displaying grid lines [FRAME ASSIST] Displaying the brightness distribution
.......sE ue[] ...................................................................................................................
OFF (No grid Grid lines (square/diagonal)are !!_ ! , } ; SSSSA_p|i _!_,n SSSSSS:/
lines displayed)/ displayed on the LCD monitor as OFF No histogram is displayed.
_Y_] gu des for compos ng the mage. A histogram (a brightness
_ "Changing the shooting information distribution as a guide for
determining the exposure) is
display" (p. 25) displayed
White-out areas are displayed
DIRECT as red, and black-out areas are
displayed as blue directly on the
image.
_,_ "Changing the shooting information
display" (p. 25), "Changing the image
information display" (p. 29)
To Next Page
Loading...
