DISASSEMBLING/ASSEMBLING PROCEDURE
3-3 Rear panel unit
Disassembling
1. Remove the harness from the rear panel
unit.
2. Remove the screw HCBK4x8SA (3 pcs.)
which secure the rear panel.
3. Remove the rear panel unit from the main
body.
Assembling
1. Mount the rear panel unit on the main
body.
2. Secure the rear panel unit to the main body
with the screw HCBK4x8SA (3 pcs.).
3. Connect the harness to the rear panel unit.
3-4 Power supply unit
CCUK3x6SA (Nejilock coated)
Disassembling
1. Remove the screw CCUK3x6SA (4 pcs.)
which secure each converter.
Assembling
1 Secure the each converter with the screw
CCUK3x6SA (4 pcs.).
For the location shown on the left,
apply Nejilock to the screw thread
before tightening.
CCUK3x6SA
Philips screwdriver No. 2
Philips screwdriver No. 2
Philips screwdriver No. 2
Nejilock
Philips screwdriver No. 2
3-4
To Next Page
Loading...
