Omega CTXL-TRH-W-W9 - Chapter 2 Setting Up the Recorder; 2.1 Placing the Recorder on the Bench Top

2-1
Setting Up the Recorder
2
2.1 Placing the Recorder on the Bench Top
Figure 2-1 shows the removal of the decorative foot cover.
1. Place the recorder on its back (so it is face up).
2. Remove the clip-on foot cover by lifting up on the cover and releasing it from
the stabilizing arm at the bottom of the recorder. This exposes the rubber feet
and stabilizing arm. The rubber feet protect the bench top surface.
CAUTION
DO NOT ATTEMPT TO SET THE RECORDER UPRIGHT ON
THE BENCH WHEN THE CLIP-ON FOOT COVER IS IN
PLACE. THE RECORDER WILL TOPPLE OVER.
Clip
Cutaway View
M4098-F2-1.eps
Figure 2-1. Foot Cover Removal
!