Figure 3-9. Main Menu Screen
If the application can not establish communication with the recorder, it will
show an error text message box, and the Find button will flash. Please check the
following for communication error:
• The recorder is connected to a serial port on the PC.
• The recorder is turned on and is operating normally.
• Go to the Settings menu and check the COM port number. Make sure you are
using the right COM port on your PC.
• Click the Find button, and the program should be able to establish
communication. The Find button will then change to Go.
Click the Go button, and the program starts to receive data from the recorder.
PC Interface Software
3
3-17
To Next Page
Loading...
