CT Analyzer User Manual
138
The following measurement types are available in Quick Test.
Meas. type Usage
Advanced Provides complete multimeter measurement functionality
and free adjustment of all measurement quantities, such as
AC or DC signal output, voltage or current output, output
frequency, measurement mode (DC, RMS or frequency-
selective) for the input, etc.
For details, please refer to section 8.4 on page 139.
Polarity Check Predefined type, especially intended for polarity checks. The
only adjustable measurement quantity is the output current.
Requires the CPOL polarity checker from OMICRON.
For details, please refer to section 8.5 on page 145.
CT Ratio Predefined type, especially intended for quick measurement
of CT ratios. Adjustable measurement quantities are the
voltage and the frequency of the output signal and the
resistance and inductance of the CT to be measured.
For details, please refer to section 8.6 on page 149.
VT Ratio Predefined type, especially intended for quick measurement
of VT ratios. Adjustable measurement quantities are the
voltage and the frequency of the output signal.
For details, please refer to section 8.7 on page 151.
Resistance Predefined type, especially intended for quick measurement
of resistances. The only adjustable measurement quantity is
the value of the output current.
For details, please refer to section 8.8 on page 154.
Impedance Predefined type, especially intended for quick measurement
of impedances. Adjustable measurement quantities are the
amplitude and the frequency of the current output signal.
For details, please refer to section 8.9 on page 156.
Reactance Predefined type, especially intended for quick measurement
of reactances. Adjustable measurement quantities are the
voltage and the frequency of the output signal.
For details, please refer to section 8.10 on page 158.
To Next Page
Loading...
