59
Operating and Configuring the CT Analyzer
5 Operating and Configuring the
CT Analyzer
5.1 Working in the User Interface
5.1.1 Displaying a Specific Card
To display a specific card, select the card by pressing the card selection keys.
The card’s tab showing the name of the selected card is then highlighted (see
Figure 5-1).
Figure 5-1 CT-Object card selected
5.1.2 Using the Soft Keys
Using the soft keys you can operate the CT Analyzer and change the user
interface level of the software.
The functionality of the soft keys is context-dependent, i.e., the software offers
different functions or selectable sets of parameters depending on the focus (i.e.,
depending on which card or field is highlighted or selected in the user interface).
If the lowermost soft key description field contains 3 points (see Save As in
Figure 5-1), additional soft key functions are available. Then you can switch the
set of displayed soft keys using the key located below the soft keys (see
Figure 5-2).
Figure 5-2 Switching the set of soft keys in the CT-Object card
1st set of soft keys
Press
2nd set of soft keys
To Next Page
Loading...
