CT Analyzer User Manual
144
Note: The results for R
p
, X
p
and L
p
(C
p
) are calculated using the parallel
equivalent circuit diagram, the results for R
s
, X
s
and L
s
(C
s
) are calculated using
the serial equivalent circuit diagram.
Use the following wiring (examples):
Figure 8-5 Wiring examples for Advanced measurement type
Crest Out,
Crest Sec,
Crest Prim
Crest factor of the output signal or the signal measured at input
sec or input prim.
The crest factor is the peak/rms ratio of a waveform. For a
sinusoidal waveform the crest factor is 1.414 (√2). The crest
factor may indicate possible signal distortion.
More detailed information can be found at
http://en.wikipedia.org/wiki/Crest_factor.
Soft key /
result
Description
To Next Page
Loading...
