7
Preface
Operator Qualifications
• Testing with the CMGPS should only be carried out by authorized and
qualified personnel.
• Personnel receiving training, instruction, direction, or education on the
CMGPS should remain under the constant supervision of an experienced
operator while working with the equipment.
Safe Operation Procedures
•The CMGPS is to be set into operation in accordance with the information
provided in section 4 ”Operating the CMGPS”.
•The CMGPS must not be opened! If the device is opened, no guarantee
claims can be made.
•Do not position the antenna of the CMGPS in an exposed location above
the lightning rod or in other locations endangered by lightning. Make
sure that the position of the lightning rod is higher than that of the antenna
in any case.
When installing the CMGPS, observe the general rules for lightning
protection complying with the industrial standard.
In addition to that, do not position the antenna within a control cabinet in
the vicinity of flashover-endangered spots.
•The CMGPS must not be used in connection with devices with an
operating voltage that exceeds 250 V r.m.s. (for further details refer to
section 6.8 ”Insulation Coordination”).
• The electric equipment of the CMGPS is to be regularly checked. Any
fault such as loose connections or defective cables is to be immediately
repaired.
• If work has to be carried out on components connected to the mains
supply, a second person is required who presses, in case of emergency,
the emergency stop and/or the main push button with overvoltage
release.
To Next Page
Loading...
General