Omnilux MINI - Precautions

12 13
OMNILUX™ MINI BLEMISH ERASER
Precautions
• DO NOT stare directly at the LED light source.
• DO NOT use the Blemish Eraser device without a
hydrocolloid.
• The Blemish Eraser device cannot be used in
charging mode.
• Unplug The 2-pin charging cable from the USB charging
port when not in use.
• Before each use, with the device switched off, clean
the Blemish Eraser device. All surfaces of the Blemish
Eraser device may be cleaned by following the cleaning
instructions.
• DO NOT use any other cleansing products other than
those stated in the cleaning instructions. Use of other
cleansing products may damage the Blemish Eraser
device.
• Store the Blemish Eraser device at room temperature in
dry conditions, away from direct sunlight.
• Don’t use the Blemish Eraser device in Direct Sunlight.
• Take care when using the Blemish Eraser device
around young children. Electrical cables can present a
strangulation hazard.
• Take care when removing the patch and hydrocolloid, as
there is a risk of damaging the top layer of the skin if it is
removed too vigorously.
• DO NOT charge the Blemish Eraser device if the USB
socket or wall adapter you are using has poor connections
or becomes hot. Make sure you plug the device into a