Omnilux MINI - Charging Status of the Blemish Eraser Device; Sensitization Test

14 15
USER GUIDE
4. When fully charged the battery will deliver 3-4 treatments
before recharging. The lifetime of the Lithium battery can
be maximized by allowing it to fully charge and then fully
discharge during regular use.
5. Always ensure the LED device is fully charged before
commencing a treatment session.
6. Unplug the 2-pin charging cable from the USB A charging
port when not in use.
Charging Status of the Blemish Eraser device
The Blemish Eraser device uses a single display LED on the
rear of the LED device and treatment LEDs to indicate the
status of charging.
Solid Green – Battery is fully charged.
Solid Orange – Battery is charging (Charging Mode).
Low Battery Mode – Identied by Treatment LEDs
Flashing – There is not enough battery charge to complete a
treatment cycle please recharge your device.
Sensitization test
Before carrying out your rst treatment you must
carry out a sensitization test to see if you are
sensitive to light or the adhesive hydrocolloid patch.
Follow the step-by-step guide below.
DO NOT attach the Blemish Eraser device to your
face, the sensitization test should be carried out on
your arm.
1. Ensure the Blemish Eraser device is fully charged.