6 7
OMNILUX™ MINI BLEMISH ERASER
The Blemish Eraser device is a silicone exible patch
containing LEDs. The LEDs generate the light.
The LEDs produce blue (415nm ± 10nm) and red (630nm
± 10nm) light in the visible spectrum. The device works
through a non-thermal mechanism called endogenous
photodynamic therapy.
The LEDs are driven by an integrated 3.7V, 37mAh Lithium
Polymer battery.
The battery is charged via a magnetic 2 pin, 4mm to
USB A connector that plugs into a standard 5v USB A
power adaptor. The device cannot be operated while
in charging mode. The charging status of the device is
indicated by a single indicator LED on the rear of the
Blemish Eraser device and the treatment LEDs.
In charging mode.
i. Solid green – battery is fully charged.
ii. Solid orange – battery charging.
The Blemish Eraser device contains a simple ON/OFF
button (
) that switches the LEDs ON/OFF. The treatment
time is 10 minutes. The device automatically turns OFF
after the 10-minute treatment cycle. The user may stop the
treatment program during the 10 minutes by pressing the
ON/OFF button.
The LED device is worn on the face and held in place by
an adhesive hydrocolloid patch. The adhesive hydrocolloid
patch is impregnated on both sides with an elastomer and
hydrogenated petroleum resin that acts as an adhesive.
The hydrocolloid patch contains the following ingredients:
CMC Carboxymethyl cellulose (Cellulose Gum), Styrene/
Isoprene Copolymer, Hydrogenated Rosin, Homopolymer,
Parafnum Liquidum (Mineral oil), PET, Niacinamide,
Camellia Sinensis Leaf Extract (Green Tea), Sodium
To Next Page
Loading...
