Omron 1S Series Practices Guide

18
7. Tuning Monitor Page
Make sure that the Status changed to “Normal end” and press the “Next” button.
(The Tuning Result Check Page appears.)
 Stopping the tuning
Press the “Stop” button.
The tuning and commands for the axis to tune are aborted. Please note that the motor will
not stop immediately depending on the operation command.

Omron 1S Series Specifications

General

Safety Function	STO (Safe Torque Off)
Motor Capacity	50 W to 15 kW
Output Power	50 W to 15 kW
Communication Interface	EtherCAT, MECHATROLINK-II/III
Feedback	Incremental Encoder
Operating Temperature	0 to +55°C
Protection Features	Overcurrent, Overvoltage
Ambient Humidity	20% to 90% RH (non-condensing)
Installation	Panel Mount
Weight	Varies by model
Storage Temperature	-20 to 85°C