Why does my Omron Inverter show error E044?
The E044 error on your Omron Inverter indicates that a subroutine, 'for next' command, or 'if' command is nested over eight levels. To resolve this, correct the program to ensure that the number of nesting levels is eight or less.
How to fix error E043 on an Omron 3G3RX2-A2?
The E043 error on your Omron Inverter means that the terminal PRG was turned ON even though no program was downloaded into the inverter. To fix this, you should create the program again and then download it to the inverter.
What to do if I get an E045 error on my Omron Inverter?
If you encounter an E045 error on your Omron Inverter, it indicates a problem within the program. This could be due to several reasons: * The 'goto' command's jump destination is pointing to the 'next' command that terminates a loop: Correct the jump destination of the 'goto' command. * A four arithmetic operation results in overflow, underflow, or division by zero: Correct the program to prevent these errors. * The 'ChgParam' and 'MonParam' command is resulting in an error because you are trying to change a parameter that does not exist, the written value is out of range or you are trying to change a parameter value that cannot be changed during inverter operation or that is protected against change by the Soft Lock Selection. In this case you should: * Correct the parameter ...
General| Category | Inverter |
|---|---|
| Frequency Control Range | 0.1 to 400 Hz |
| Enclosure Rating | IP20 |
| Series | 3G3RX2-A2 |
| Output Frequency | 0 to 400 Hz |
| Current Range | 3.5 A |
| Control Method | V/f control, Sensorless vector control |
| Overload Capacity | 150% for 60 seconds |
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Ground fault |
| Communication | RS-485 (Modbus ASCII/RTU) |
| Operating Temperature | -10°C to +50°C (14°F to 122°F) |
| Storage Temperature | -20 to +60°C (-4 to 140°F) |
| Cooling Method | Fan Cooled |
To Next Page