EasyManua.ls Logo

Omron CJ1W-EIP21 - Page 67

Omron CJ1W-EIP21
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-25
1 Introduction
CJ-series EtherNet/IP Units Operation Manual for NJ-series CPU Unit (W495)
1-5 EtherNet/IP Communications
Procedures
1
1-5-3 Using EtherNet/IP Network Functions
Using BOOTP
1
Use the Sysmac Studio to set the initial settings of the EtherNet/IP
Function Module.
Section 5 Sysmac Studio
Settings for the EtherNet/IP
Unit
Set the BOOTP settings.
2
Check operation.
Check the event log to see if BOOTP started.
Check online status with the device variables for the CJ-series Unit.

Table of Contents

Related product manuals