Omron CX-PROGRAMMER - INTRODUCTION GUIDE - 5-1. Entering Normally Open Contact

After checking the cursor position at the upper left of Ladder Window, start programming.
5-1. Entry of Normally Open Contact
Press [C] from a keyboard to open the [New Contact] dialog.
C
0
0 of the upper
digit of an
address can
be omitted.
ENT
Switch 1
Enter a symbol
comment.
ENT
0 of the upper digit of an address is omitted when shown.
[.] (period) is displayed between a channel number and a relay number.
Deletion of instructions
z Move the cursor to the instruction
and then press the DEL key.
z Move the cursor to the right cell of
the instruction and press the BS key.
Installation
to Startup
Installation
to Startup
Opening a
new project
Opening a
new project
Device type
settings
Device type
settings
Creating a
program
Creating a
program