Output Window
automatically opens.
5-2. Entry of Coil
Press [O] from a keyboard to open the [New Coil] dialog.
O
100
ENT
Coil 0
ENT
Press [R] to normalize a rung.
R
Useful Function: Automatic check of duplicated coils
If a duplicated coil is entered during program creation, the following message is
displayed and you can notice that the coil is duplicated right away.
Useful Function: Automatic check of duplicated coils
If a duplicated coil is entered during program creation, the following message is
displayed and you can notice that the coil is duplicated right away.
Press the [ESC] key to close
the open Output Window.
The place of a duplicated coil in the program is displayed.
Double-click by using a mouse (or press F4). The cursor
moves to the place of the applicable coil on Ladder Window.
Double-click
Double-click
Rungs are also normalized when you move the
cursor position to the cell inverted in blue by
pressing the arrow keys from a keyboard or
using a mouse.
Installation
to Startup
Installation
to Startup
Opening a
new project
Opening a
new project
Device type
settings
Device type
settings
Creating a
program
Creating a
program
To Next Page
Loading...
