Omron CX-PROGRAMMER - INTRODUCTION GUIDE - 5-7. Differential Contact Up Entry; 5-8. Differential Contact Down Entry

5-7. Entry of Differential Contact…Up
C
100
ENT
Click
Click [Up].
ENT
This entry method is available only for
CS/CJ and CV series PLCs.
For the other series PLCs, use DIFU (13).
5-8. Entry of Differential Contact…Down
C
101
ENT
Click
This entry method is available only for
CS/CJ and CV series PLCs.
For the other series PLCs, use DIFD (14).
Click [Down].
Installation
to Startup
Installation
to Startup
Opening a
new project
Opening a
new project
Device type
settings
Device type
settings
Creating a
program
Creating a
program