Omron CX-PROGRAMMER - INTRODUCTION GUIDE - 5-19. Rung Copy & Paste; 5-20. END Instruction

5-19. Edit of Rungs …Copy & Paste
Refer to the former sections to enter a rung.
Ctrl C
Move the cursor to
this position. The
rung is inverted as
shown right.
Move the cursor to
this position. The
rung is inverted as
shown right.
(Copy a rung)
 You can copy instructions selected by dragging a mouse.
 You can also cut selected rungs (instructions) by [Ctrl]+[X].
↓
Press the ↓ key to
move the cursor to
this position.
Press the ↓ key to
move the cursor to
this position.
Ctrl
V
(Paste a copied rung)
Click each instruction
and then change the
bit numbers.
Click each instruction
and then change the
bit numbers.
 When making a mistake, press or [Ctrl+Z] for Undo
(return to the previous operation)
press or [Ctrl+Y] for Redo (go to the next operation)
Installation
to Startup
Installation
to Startup
Opening a
new project
Opening a
new project
Device type
settings
Device type
settings
Creating a
program
Creating a
program
5-20. Entry of END Instruction
At the creation of a new project, a
section of the END instruction only is
automatically generated.
You do not need to enter an END
instruction.
At the creation of a new project, a
section of the END instruction only is
automatically generated.
You do not need to enter an END
instruction.
Note:
The END section is not generated when you load a program
created with CX-Programmer V2 or the former versions.