Omron CX-PROGRAMMER - INTRODUCTION GUIDE - 5-16. Advanced Instructions: Fun No. Entry

5-16. Entry of Advanced Instructions 3 - Entry by Fun No.
Show the [New Instruction] dialog.
Show the [New Instruction] dialog.
I
021
ENT
Enter
#0 D0
The instruction
corresponding to the
entered Fun No. is
displayed.
The instruction
corresponding to the
entered Fun No. is
displayed.
ENT
R
Refer to the section 5-4 to enter a rung comment.
Note:
The Fun No. of MOV
depends on PLC types.
CS-series -> 021
CJ-series -> 021
CV-series -> 030
C-series -> 21
Note:
The Fun No. of MOV
depends on PLC types.
CS-series -> 021
CJ-series -> 021
CV-series -> 030
C-series -> 21
Installation
to Startup
Installation
to Startup
Opening a
new project
Opening a
new project
Device type
settings
Device type
settings
Creating a
program
Creating a
program