Online
to Transfer
Online
to Transfer
Monitoring
Monitoring
Force On
Force Off
Force On
Force Off
Program
Check
Program
Check
Online
Edit
Online
Edit
(5)Then retrace rungs to find a cause from the contact 1.01. As well as the operations
so far, move the cursor to the contact 1.01 and press the [Space] key.
Space
(6)The focus moves to the coil 1.01. As it turned out, the cause was the contact 0.01
that was not turned on.
Press the [Space] key to jump from a coil to a contact having the same address as the
coil or from a contact to a coil in reverse.
Press the [N] key for another jump from a contact or coil at the cursor position to a next
one having the same address.
To move back to the position of the last jump, press the [B] key.
This is a useful function available in SYSMAC Support Software.
CX-Programmer inherits it.
To Next Page
Loading...
