E2C
E2C
24
E2C-A
j
4A
$
If morethanE2C-A
j
4A Amplifier Unit is vertically mountedwith
the P2CF-11 or P2CF-08 side by side, it will be convenient to
leave a 20-mm space on both the upper and lower sides where
the hooks are located.
Hook
Duct
Panel
P2CF-11
P2CF-08
$
Panel Mounting
1. If the Y92F-30 Mounting Adapter is used for the panel
mounting of the E2C-A
j
4A, insert the E2C-A
j
4A into the
square hole of the panel first. Next attach the Mounting
Adapter from the rearsideand press the MountingAdapterto
reduce the space between the Adapter and the panel as
much as possible, then secure the Mounting Adapter with
screws.
Panel
Y92F-30
2. If the Y92F-70 or Y92F-71 Mounting Adapter is used, just
insert the E2C-A
j
4A into the square panel hole. If the panel
coating is too thick and the hooks donot snap on, spread out
the hooks appropriately up and down after inserting the
E2C-A
j
4A into the hole.
Spread after insertion
Panel
Hook
Spread after insertion
Dismounting the Amplifier Unit
$
In the case of the Y92F-30 Mounting Adapter,loosen the screws
of the Adapter, spread out the hooks, and remove the Mounting
Adapter.
$
In the case of the Y92F-70 or Y92F-71 Mounting Adapter, press
thehookinwardsusing thethumbandindex fingerofbothhands,
and press the E2C-A
j
4A towards the front side.
Wiring the Self-diagnostic Output
$
If self-diagnostic output will not beused, connectthe yellow lead
wire to the 0-V terminal or cut and coverthe yellow lead wire with
insulation tape so that the yellow lead wire will not be in contact
with other terminals.
OMRON Corporation
Systems Components Division H.Q.
28th Fl., Crystal Tower Bldg.
1-2-27, Shiromi, Chuo-ku,
Osaka 540 Japan
Phone: 06-949-6012 Fax: 06-949-6021
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. D030-E1-5
In the interest of product improvement, specifications are subject to change without notice.
Printed in Japan
0997-0.5M
a
To Previous Page
Loading...
