Omron E2C - Amplifier Unit Mounting Procedures; E2 C-JC4 A Mounting

E2C
E2C
23
Mounting the Amplifier Unit
E2C-JC4A
$
Vertical Mounting
1. Mount the Mounting Bracket with the M3 screw provided with
the E2C-JC4A.
2. Slide and insert the protruding part of the E2C-JC4A into the
hole of the mounting bracket.
3. Mount the E2C-JC4A with the mounting screw.
4. Mount the cover on the casing.
Mounting screw
Mounting Bracket
Mounting surface
M3 screw
$
Side Mounting
1. Remove the cover tightening screw and mounting screw.
2. Mount the cover on the casing using the M3 screw provided
with the E2C-JC4A.
3. Mount the E2C-JC4A by inserting and tightening the M3
screws on the side of the E2C-JC4A.
Cover tightening screw
Mounting screw
Mounting surface
M3 screw
M3 screws
$
After adjusting the E2C-JC4A, affix the caution label over the
adjuster hole of the cover to prevent the mis-operation.
E2C-JC4AP
$
Mounting
1. Mount the front part of the E2C-JC4AP to the Mounting
Bracket provided or a DIN track.
2. Press the rear part of the E2C-JC4AP onto the Mounting
Bracket or DIN track.
Rear part
Front part
Fixture rail (yellow)
DIN track or Mounting Bracket
$
Dismounting
3. Pull the fixture rail with a flat-blade screwdriver so that the
E2C-JC4AP can be dismounted with ease.
E2C-WH4A(F)
$
Mount the E2C-WH4A(F) to a DIN track as shown in the
following illustration.
$
Hook part (A) of the E2C-WH4A(F) to the DIN track and press
E2C-WH4A(F) in the direction indicated by the arrow (B).
DIN35 track (PFP-100N or PFP-100N2)
$
Dismounting from DIN Track
Pull the rail stopper indicated by arrow (C) upwards with a
flat-blade screwdriver to dismount the E2C-WH4A(F) from the
DIN track. If the track is DIN35 track, the E2C-WH4A(F) can be
easily dismounted by creating a 30-mm space between the
E2C-WH4A(F) and other objects.
Rail stopper (white)
(C)
30 mm min.
30 mm min.