Omron E5 Z Series User Manual

141
Advanced Function Setting Level Section 5-7
• .This parameter switches the logic of the MB command (communications
writing switch) for the SYSWAY communications protocol
• The MB command (communications writing switch) is the equivalent of
the MB command (remote/local switch) of the E5@J.
• The setting indicated by the shaded area is the default (same logic as
E5@J).
(Terms in parentheses () are the terms used on the E5@J.)
Related Parameters
Communications writing (adjustment level): Page 108
Protocol setting (communications setting level): Page 149
Alarm 1, 2, or 3 outputs are prevented from turning ON until after the delay
times set in these parameters have elapsed.
• Set the time for which the ON delay is to be enabled.
• To disable the ON delay, set 0.
Related Parameters
Alarm 1 to 3 type (initial setting level): Page 124 to 126
rlrv MB Command Logic Switching
Communications must be supported.
CompoWay/F must be selected as
the protocol.
Set
value
Text data of MB command
0000 0001
OFF Communications writing enabled
(remote mode selection)
Communications writing disabled
(local mode selection)
ON Communications writing disabled
(local mode selection)
Communications writing enabled
(remote mode selection)
Function
Setting
See
See
a1on Alarm 1 ON Delay
Alarm 1 must be assigned, and the
alarm 1 type must not be 0 or 12.
a2on Alarm 2 ON Delay
Alarm 2 must be assigned, and the
alarm 2 type must not be 0.
a3on Alarm 3 ON Delay
Alarm 3 must be assigned, and the
alarm 3 type must not be 0.
Setting range Unit Default
0 to 999 Second 0
Function
Setting
See
See
■
■

Omron E5 Z Series Specifications

General

Brand	Omron
Model	E5 Z Series
Category	Temperature Controller
Language	English