1-4
Feat ure s Section 1-1
Overview
Note The Communications Write setting is ON by default.
Write Area
Write data
Output Enable Bit
SP
Bank 0: Alarm 1 value
Bank 0: Alarm 1 upper limit
Bank 0: Alarm 1 lower limit
Bank 0: Alarm 2 value
Bank 0: Alarm 2 upper limit
Bank 0: Alarm 2 lower limit
Operation command
Read Area
Read data
PV (channel 1)
MV monitor (heating)
Status (4 bytes)
Note The above monitor val-
ues and setting data
are all for channel 1.
Output (OUT) Area
Input (IN) Area
Master
To Next Page
Loading...
