Omron E5ARER - Page 56

4-9
I/O Allocation Section 4-2
Remote I/O Com-
munications
E5@R Status
Note: The status for Setting Area 1 would be as follows when read:
• RSP input error: Clear
• Potentiometer error: Clear
• Display range exceeded: Clear
• Input error: Clear
• Control output (heating side) and control output (cooling side): Clear
• Alarm 1, alarm 2, alarm 3, and alarm 4: Clear
• AT: Clear
• Run/stop: ON (Stop)
• Auto/manual: Hold previous value
• SP mode, MV tracking: Refresh
• Control output type (heating), control output type (cooling): Refresh
---
OFF
Not used.
---
OFF
Not used.
ErrorRSP input error
0123456789101112131415
Bit
Outputs
16
0 (OFF) 1 (ON)
OFF ON
Error
No error
No error
No error
No error
Error
Error
OFF
OFF ---
---
Status
OFF
---
OFF ON
OFF
---
OFF ON
OFF ON
OFF ON
OFF ON
Not used.
Control output (heating side)
Not used.
Potentiometer error
Display range exceeded
Input error
Not used.
Control output (cooling side)
Not used.
Alarm 1
Alarm 2
Alarm 3
Alarm 4
Errors
000000
---
---
OFF
OFF
Not used.
Not used.
Not used. ---
OFF
0 0 0
16171819202122232425262728293031
Bit
Operation status
0 0
15
Not used.
Not used.
Write mode
0 (OFF) 1 (ON)
AT cancel AT execute
Run Stop
Setting Area 1
OFF
Backup
RAM = EEPROM
Setting Area 0
---
RAM write
RAM EEPROM
OFF
---
Status
OFF (Read-only) ON (Read/write)
Automatic Manual
LSP RSP
OFF ON
Pulse voltage output Linear current output
Pulse voltage output Linear current output
Run/stop
EEPROM
AT execute/cance
Setting Area
Communications write
Auto/manual
SP mode
MV tracking
Control output type (heating side)
Control output type (cooling side)
Output
type