Omron FH-L550 - Page 107

*2.
The FH-S£££ has two channels to connect Camera Cables. Connection to two channels makes image
transfer two times faster than connection to one channel: high speed mode using two channels can transfer
approximately four times as many images as standard mode using one channel.
*3. Each channel can be used to connect up to two Cable Extension Units: up to four extension units, two units
per one channel, can be connected by using two channels.
Connection Configuration
Connection configuration of FH-1000/2000/3000/5000 Sensor Controller and Camera are the bellows.
Con-
figu-
ra-
tion
Connection configuration using the maximum length of Camera
Cables
Remarks
1
15 m
(1)
15 m
(2)
15 m
(3)
*1
-
2
15 m
(1)
15 m
(4)
15 m
(2)
15 m
(5)
15 m
(3)
15 m
(6)
*1
CH1
CH2
Camera cable
connector CH2
Camera cable
connector
CH1
3
5 m
(1)
5 m
(2)
5 m
(3)
*1
-
4
5 m
(1)
5 m
(2)
5 m
(3)
5 m
(4)
5 m
(5)
5 m
(6)
*1
CH1
CH2
Camera cable
connector CH2
Camera cable
connector
CH1
*1. Select the Camera Cables between the Controller and Extension Unit, between the Extension Units, and be-
tween the Extension Unit and Camera according to the connected Camera.
Dif
ferent types or lengths of Camera Cables can be used for (1), (2), and (3) as well as for (4), (5), and (6).
However, the type and length of Camera Cable (1) must be the same as those of Camera Cable (4), (2)
must be the same as (5), and (3) must be the same as (6).
3 Configuration
3-49
FH Series Vision System Hardware Setup Manual (Z366-E1)
3-3 Camera Cable
3
3-3-5 Cable Extension Units