Connection connector for FZ-VP£
Connection connector on the Sensor Controller
Pin No.
Signal name
Pin No.
Signal name
CN3 CN4 CN1 CN2
B12 RUN0/BUSY1 15 - RUN0
B13 BUSY0 17 - BUSY0
B14 GATE0 - 15 GATE0
B15 OR0 18 - OR0
B16 READY0 16 - READY0
B17 DO0 - 17 DO0
B18 DO2 - 19 DO2
B19 DO4 - 21 DO4
B20 DO6 - 23 DO6
B21 DO8 - 25 DO8
B22 DO10 - 27 DO10
B23 DO12 - 29 DO12
B24 DO14 - 31 DO14
B25 DO15 - 32 DO15
Note: 1. PIN_No.1 of CN4 is unified in 1 system with shorting COMIN0-2 of FH series.
2. PIN_No.2 of CN4 is unified in 1 system with shorting COMOUT0-3 of FH series.
FH-VPX-F160
l
Connection Structure (FH-VPX-F160)
Parallel connector
(CN1/CN2)
FH controller
Connecting the FZ-VP and the FH-VPX-
* After the connection, lock it securely.
PLC, terminal blocks or
other products
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
CN1
CN2
F160-VP
FH-VPX-F160
CN3
Connector No. Connection destination Note
CN1 Connect to the parallel port CN1 on the Sensor Con-
troller.
Even if you connect the CN1 and
CN2 reversely by mistake, it does
not work but will not be damaged.
CN2 Connect to the parallel port CN2 on the Sensor Con-
troller
.
CN3 Connect to the Parallel I/O cable F160-VP. -
6 I/O Interface
6-25
FH Series Vision System Hardware Setup Manual (Z366-E1)
6-1 Parallel Interface
6
6-1-4 Other (Parallel Converter Cable)
To Next Page
Loading...
